Compact HF / 50 MHz transceiver for home and field operations. Double-conversion receiver with frequency range 0.03-56 MHz, 10 KHz bandwidth roofing filter, full DSP features, 100 Watt output power, automatic antenna tuner (ATU) built-in. Ideated in Japan, year of introduction 2010.
Reference market : amateur-radio
FT-450D specifications
General |
Frequency coverage | |
---|---|
Receive | 0.0300 ~ 56.0000 MHz [1] |
Transmit | 1.8 / 3.5 / 5.3 [2] / 7 / 10 / 14 / 18 / 21 / 24 / 28 / 50 MHz band |
Mode | |
CW / FSK / LSB / USB / AM / FM | |
Tuning step | |
1 / 10 / 20 / 100 / 200 Hz / 1 / 2.5 / 5 / 6.25 / 9 / 10 / 12.5 / 15 / 20 / 25 / 50 / 100 KHz |
Receiver |
Sensitivity [3] | |
---|---|
SSB [4] | 0.25 uV (1.8~2 MHz, 10dB S+N/N) 0.25 uV (3.5~30 MHz, 10dB S+N/N) 0.20 uV (50~54 MHz, 10dB S+N/N) |
AM [4] | 2.0 uV (1.8~2 MHz, 10dB S+N/N) 2.0 uV (3.5~30 MHz, 10dB S+N/N) 1.0 uV (50~54 MHz, 10dB S+N/N) |
FM [4] | 0.5 uV (28~30 MHz, 12dB SINAD) 0.3 uV (50~54 MHz, 12dB SINAD) |
Selectivity | |
CW | > 0.25 KHz (-6dB)
< 0.70 KHz (-60dB) |
SSB | > 2.20 KHz (-6dB)
< 4.50 KHz (-60dB) |
AM | > 6.0 KHz (-6dB)
< 20.0 KHz (-60dB) |
FM-N | > 9.0 KHz (-6dB)
< 25.0 KHz (-60dB) |
FM | > 15.0 KHz (-6dB)
< 30.0 KHz (-60dB) |
RF preamplifier | |
Yes | |
RF attenuator [5] | |
20 dB | |
Image rejection | |
> 80 dB | |
IF rejection | |
> 80 dB (1.8-29.7 MHz amateur bands) > 65 dB (50 MHz amateur band) |
|
IF-shift range | |
± 1.0 KHz | |
Notch filter | |
Manual | Yes |
NB (Noise Blanker) | |
Yes | |
DNR (Digital Noise Reduction) | |
Variable in 11 steps | |
AGC (Automatic Gain Control) | |
Fast, mid, slow, off | |
Frequency stability | |
± 1 ppm max with temperature +25°C after warm-up | |
IF (Intermediate Frequency) | |
1° | 67.899 MHz |
2° | 24 KHz |
IF roofing filter | |
10 KHz | |
Squelch sensitivity [3] | |
CW / SSB / AM | 2.5 uV (1.8~30 MHz) 1.0 uV (50~54 MHz) |
FM | 0.32 uV (28~30 MHz) 0.16 uV (50~54 MHz) |
CW features | |
Spot-tone Semi break-in / full break-in 400~800 Hz pitch adjustment in 100 Hz steps LSB/USB reverse mode |
Transmitter |
Output power | |
---|---|
SSB / CW / FSK / FM | 100 W (adjustable) |
AM | 25 W (adjustable) |
Spurious emission | |
Harmonics | < -60 dB (1.8~30 MHz, amateur bands) < -70 dB (50 MHz, amateur band) |
Carrier suppression (SSB) | |
> 60 dB | |
Unwanted sideband suppression (SSB) | |
> 60 dB | |
Maximum deviation (FM) | |
± 2.5 / 5 KHz | |
Audio response | |
< 300-2400 Hz (-6dB) | |
Microphone | |
600Ω | |
CW features | |
4~60 wpm keyer | |
FSK / RTTY features | |
170 / 200 / 425 / 850 Hz shift | |
Antenna tuner | |
Impedance range | 16.7-150Ω (1.8~50 MHz) |
Memories for tunning data | 100 |
Features |
Memory | |
---|---|
500 regular memories, up to 10 groups 2 home channels 1 quick memory channel 2 pairs for programmed scan limits |
|
Display | |
10 Hz frequency resolution 31-segments signal meter bar |
|
Selective calling | |
CTCSS | |
Antenna | |
SO239 50Ω | |
Power supply | |
13.8 VDC (±10%) | |
Power consumption | |
1.5A RX, typ 22A TX, max power |
|
Audio power | |
2.2 W on 4Ω | |
Audio output | |
Jack 3.5 mm headphone Jack 3.5 mm external speaker (4~16Ω) |
|
Connections | |
DB-9 RS232C CAT (Computer control) Jack 6-pin (TNC data in/output) Jack 8-pin (optional external antenna tuner) Jack 10-pin (band selection data for external power amplifier) Jack 3.5 mm (CW key) |
Mechanical and environmental data |
Operating temperature | |
---|---|
from -10°C to +50°C | |
Dimensions | |
229 (W) x 84 (H) x 217 (D) mm | |
Weight | |
4.0kg |
- 1.8~54 MHz specified performance guaranteed, amateur band only.
- USA and UK version only, see following table.
- IPO and Attenuator Off.
- 2.4 KHz SSB bandwidth, 6 KHz AM bandwidth, 15 KHz FM bandwidth.
- An attenuator is always On between 0.03-1.7 MHz.
Updated | Complete | UK - NORTHERN IRELAND
378 pages | 300+ Airports and Airfields
Voice com. | ACC | FIC | VOLMET | ACARS | VDL | ILS | VOR | DME
The current "450D" transceiver includes some features not offered with the original FT450 (ATU optional) and FT450AT that have been discontinued. Features now included are: 300Hz CW IF-filter, built-in ATU, illuminated key buttons, front-feet stand, dynamic microphone MH-31A8J.
FT-450 description :
The Yaesu FT-450D is a compact transceiver complete with an Automatic Antenna Tuner (ATU) weighing only 4kg. This lightweight package is designed to be used as a desktop radio or in portable applications. The FT450D can also be used car / mobile with the mobile bracket accessory (MMB-90). The rugged aluminum die-cast chassis with its quiet, thermostatically controlled cooling fan, provides a solid foundation for the 100 Watts push-pull power amplifier (with RDF100HHF1 MOSFET) on all HF bands (1.8 to 29.7 MHz) plus the low-VHF band (50 MHz). The Yaesu FT450D IF-Width and IF-Shift features are the primary tools for best interference reduction, the IF-Contour control may also yield additional signal-enhancement benefits on the net residual bandwidth. The Contour filtering system provides a gentle shaping of the IF pass-band to suppress or enhance particular frequency components, thus improving the sound and/or readability of a received signal. This DSP filter is a unique capability of the receiver, providing either Nulling or Peaking of tunable segments to suppress interference and/or excessive frequency components on an incoming signal. The amount of Nulling / Peaking and the bandwidth over which it is applied are adjustable via the Menu. Of-course, the IF-Notch filter may also be utilized in conjunction with the other filter systems to significant advantage.
FT-450D IF bandwidths :
Mode | Nominal | Adjustment range |
---|---|---|
CW | 2.4 KHz | 300 / 500 Hz / 2.4 KHz |
Data | 3.0 KHz | 300 Hz / 2.4 / 3.0 KHz |
SSB | 2.4 KHz | 1.8 / 2.4 / 3.0 KHz |
AM | 6.0 KHz | 3.0 / 6.0 / 9.0 KHz |
FM | 9.0 KHz | 9.0 / 15.0 KHz |
FT-450D receiver block diagram :
FT450D Receiver block diagram
A double conversion superheterodyne system with 8 band-pass filter for eliminate out of band strong interference. The RF amplifier with 2 x 2SK520 JFET, for high IP3, feed a 4-pole 10 kHz bandwidth roofing-filter in the 1° IF, just after the front-end mixer. This filter provides narrow-band selectivity to protect the following circuits. Then, the high performance DSP (400 MHz) at the 2° IF stage permits easy management of AGC, filters, noise reduction, for clear and quiet reception. The RF attenuator and preamplifier (IPO, Intercept Point Optimization) feature allow the operator to optimize the dynamic range window.
FT-450D IF shift/width control :
Independent fast IF SHIFT Control, vary the IF shift higher or lower for effective interference elimination. IF WIDTH Tuning, provides selectable IF passband widths to fight QRM (SSB 1.8 / 2.4 / 3.0 KHz, CW 300 / 500 Hz / 2.4 KHz).
Yaesu FT-450D IF Shift (left) and Width (right) control
The IF-Shift and IF-Width features together form a very effective interference-fighting filtering system.
FT-450D DSP :
The legendary Yaesu IF DSP (Digital Signal Processing) system, well regarded among top and world-class DX operators, is now available in an easy to operate package. The new IF DSP uses an Analog Devices ADSP-BF531 IC (Integrated Circuit), with high speed 16-bit, floating point architecture. Designed and programmed with the unique objective of "Enhanced Transmit Signal Quality" and "Advanced Receiving Interference Suppression". These features now come in one easy to operate HF & 50 MHz RTX, ideal for everyone, new licensee or serious DX operator.
Yaesu FT-450D DSP system with ADSP-BF531
FT-450D digital modes :
PSK, FSK, and Packet operation is easily accomplished on the FT-450D by connecting a TNC (Terminal Node Controller) to the transceiver, as in the illustration.
Yaesu FT-450D digital mode operation with TNC
FT-450D TX features :
The 450D has a unique Digital Microphone Equalizer with to preset functions. The custom settings may be set to match your voice characteristics for maximum power and punch, designed for optimal DX operation. VOX operation is now controlled by the DSP system. Enjoy smooth and seamless Voice Operated TX/RX control with this latest technology. Two Voice Memories for SSB/AM/FM modes. Store up to Ten seconds of audio in each memory, for contesting and portable field operation. The DSP system now makes this feature easy to operate.
FT-450D automatic antenna tuner :
The transceiver's ATU (Automatic Antenna Tuner) includes 100 memories for quick tuning during field operation when using a folded dipole, etc. In addition, the Yaesu original and unique Antenna Tuning systems, such as the external ATU FC-40 or ATAS-120, are ready to be automatically operated with the FT-450D front panel controls.
FT-450D 5.2 MHz band :
Channel number (USA/UK) | Frequency (USA) | Frequency (UK) |
---|---|---|
US5-001 / UK5-FA | 5.3320 MHz | 5.260 MHz |
US5-002 / UK5-FB | 5.3480 MHz | 5.280 MHz |
US5-003 / UK5-FC | 5.3585 MHz | 5.290 MHz |
US5-004 / UK5-FK | 5.3730 MHz | 5.368 MHz |
US5-005 / UK5-FF | 5.4050 MHz | 5.373 MHz |
--- / UK5-FE | --- | 5.400 MHz |
--- / UK5-FM | --- | 5.405 MHz |
FT-450D chassis :
The Rugged aluminum die-cast chassis with large cooling fan is made for your heavy-duty, extended high power operation. The newly designed push-pull power MOSFET (2 x RDF100HHF1 device) amplifiers guarantee powerful and reliable 100 Watt output operation.
Yaesu FT-450D rugged aluminum die-cast chassis with cooling fan
The Yaesu FT-450D rugged 490 cc aluminum die-cast chassis, with a large 70 x 70mm quiet thermostatically controlled cooling fan, is a solid foundation of the power amplifier during long hours of field use or home contesting operation.
FT-450D price
We have collected for your convenience the Yaesu FT450D sale price (UK Pounds) and its trend over time. Useful to guarantee a cheaper purchase of this radio and to put it for sale in the second-hand market. Of course offers, accessories, warranty terms and conditions can lead to different figures.
Price | Date | Condition |
GBP 660.00 (769EUR) |
2021-jan | Brand-new |
GBP 584.95 | 2020-feb | Brand-new |
GBP 493.00 (550EUR) |
2020-jan |
Second Hand Excellent condition, boxed |
GBP 499.00 | 2020-jan |
Second Hand Good condition overall, comes with microphone, power lead. Boxed |
FT-450D review
8P6GE | 18 january 2022 |
Had this radio for 9 years, beautiful little radio worth every penny. My problem is I live near the sea so the salt air corrode the RF-IF and PA boards, looking for 2 boards for it or another one...
[End post]
Your opinion on merits, defects, experiences, with this radio set is welcome. Write your review, after a technical evaluation by our staff if found suitable will be published on this page. We thank you for your precious contribution.