Specifications Prices
High performance HF/50 MHz transceiver. Double conversion receiver with the first IF frequency at 9 MHz. 300 / 600 Hz and 3 / 6 / 15 kHz roofing filters with a sharp shape factor. Dynamic range 108dB, IP3 +37dBm. Power output 5-100 Watts, built-in antenna tuner. CW, FSK and PSK decode. Color 4.3-inch TFT display with RF and AF spectrum scope, analog or bar-graph meter. Ideated in Japan, year of introduction 2013.
Reference market : amateur-radio
FT-DX3000D specifications
| General |
| Frequency coverage | |
|---|---|
| Receive | 0.0300 ~ 56.0000 MHz [1] |
| Transmit | 1.8 / 3.5 / 5.1675 [7] / 5.2 / 7 / 10 / 14 / 18 / 21 / 24 / 28 / 50 MHz band |
| Mode | |
| CW / FSK (RTTY) / PSK / LSB / USB / AM / FM | |
| Tuning step | |
| 1 / 5 / 10 / 100 Hz / 2.5 / 5 / 6.25 / 9 / 10 / 12.5 / 25 / 100 KHz / 1 MHz | |
| Receiver |
| Sensitivity | |
|---|---|
| CW/SSB [2] | 4 uV (0.5-1.8 MHz, 10dB S+N/N).
0.16 uV (1.8-30 MHz, 10dB S+N/N, pre2 ON). 0.125 uV (50-54 MHz, 10dB S+N/N, pre2 ON). |
| AM [3] | 28 uV (0.5-1.8 MHz, 10dB S+N/N).
2 uV (1.8-30 MHz, 10dB S+N/N, pre2 ON). 1 uV (50-54 MHz, 10dB S+N/N, pre2 ON). |
| FM [4] | 0.5 uV (28-30 MHz, 12dB SINAD, pre2 ON).
0.35 uV (50-54 MHz, 12dB SINAD, pre2 ON). |
| Selectivity | |
| CW/FSK | > 500 Hz (-6dB)
< 750 Hz (-60dB) |
| SSB | > 2.4 kHz (-6dB)
< 3.6 kHz (-60dB) |
| AM | > 6 kHz (-6dB)
< 15 kHz (-60dB) |
| FM | > 12 kHz (-6dB)
< 25 kHz (-60dB) |
| RF preamplifiers | |
| 10 dB (pre1)
17 dB (pre2) |
|
| RF attenuator | |
| 6 / 12 / 18 dB | |
| DR (Dynamic Range) [5] | |
| 108.5 dB (10 KHz spaced signals, pre1 ON or OFF).
106 dB (2 KHz spaced signals, pre1 ON or OFF). |
|
| IP3 (3rd order intercept point) [5] | |
| +37 dBm (10 KHz spaced signals, pre OFF).
+25 dBm (10 KHz spaced signals, pre1 ON). +33 dBm (2 KHz spaced signals, pre OFF). +21 dBm (2 KHz spaced signals, pre1 ON). |
|
| Image rejection | |
| > 70 dB (1.8-30 MHz, amateur bands)
> 60 dB (50 MHz, amateur band) |
|
| IF-shift range | |
| ± 1 kHz | |
| Notch filter | |
| Manual | > 70 dB (wide/narrow) |
| Automatic | Yes |
| NB (Noise Blanker) | |
| Wide/narrow, and level adjustable | |
| DNR (Digital Noise Reduction) | |
| 15 levels adjustable | |
| RIT (Receiver Incremental Tuning) | |
| ± 9.999 KHz | |
| AGC (Automatic Gain Control) | |
| Off / slow / mid / fast / slopped | |
| Frequency stability | |
| ± 0.5ppm with temperature from -10°C to +50°C after 1' warm-up | |
| IF (Intermediate Frequency) | |
| 1° | 9 MHz |
| 2° | 30 KHz (CW / FSK / PSK / SSB).
24 KHz (AM / FM) |
| IF roofing filter | |
| 0.3 [6] / 0.6 / 3 / 6 / 15 kHz | |
| Squelch sensitivity | |
| CW/SSB/AM | 2 uV (1.8-54 MHz amateur bands, pre2 ON) |
| FM | 1 uV (28-54 MHz amateur bands, pre2 ON) |
| CW features | |
| CW decoder
Zero-in display APF filter Semi break-in / full break-in U/LSB mode reversal |
|
| FSK / PSK features | |
| RTTY decoder
PSK decoder BPSK and QPSK compatible |
|
| Transmitter |
| Output power | |
|---|---|
| CW / FSK / SSB / FM | 5~100 W |
| AM | 2~25 W |
| Spurious emission | |
| Out-of-band | < -50 dB (1.8~29.7 MHz) |
| Harmonics | < -60 dB (1.8~29.7 MHz) < -65 dB (50 MHz) |
| Carrier suppression (SSB) | |
| > 60 dB | |
| Unwanted sideband suppression (SSB) | |
| > 60 dB | |
| Intermodulation products (SSB) | |
| -31 dB (14 MHz, 100W PEP) | |
| Maximum deviation (FM) | |
| ± 2.5 kHz (narrow)
± 5.0 kHz (wide) |
|
| Occupied bandwidth (FM) | |
| 16 KHz | |
| Audio response | |
| 100~4000 Hz max, adjustable (-6dB) | |
| Microphone | |
| 600Ω (200~10kΩ) | |
| XIT (Transmitter Incremental Tuning) | |
| ± 9.999 KHz | |
| CW features | |
| 300~1050 pitch (10Hz/step)
4~60 WPM keyer Iambic A/B selection 5 message memory 20-3000ms CW-VOX delay |
|
| Antenna tuner | |
| Impedance range | 16.7-150Ω (1.8~29.7 MHz) 25-100Ω (50~54 MHz) |
| Channel memory | 11 (one for band), 89 (most-recent tuning points) |
| Tuning accuracy | < 2:1 |
| Features |
| Memory | |
|---|---|
| 99 regular memories, up to 6 banks
9 pairs for programmed scan limits 5 quick memories 3 band-stack for each VFO's register 2 VFO |
|
| Display | |
| 10.9cm color TFT
1 Hz frequency resolution 20 / 50 / 100 / 200 / 500 KHz / 1 MHz spectrum scope Audio spectrum scope |
|
| Selective calling | |
| 50-tone CTCSS | |
| Antenna | |
| 3 x SO239 50Ω | |
| Power supply | |
| 13.8 VDC ±10% | |
| Power consumption | |
| 1.8A RX, no signal
2.1A RX, signal present 23A TX, max output power |
|
| Audio power | |
| 2.5 W on 4Ω | |
| Audio output | |
| Jack 6.35 mm headphone | |
| Connections | |
| DB-9 RS232C (CAT, PC)
USB (PC) 2 x Jack (in/out u-Tune unit) RCA (+13.8VDC, 200mA) RCA (PTT) RCA (ALC) RCA (9 MHz IF output) RCA (TX, open collector) RCA (RX antenna output) Jack 3.5 mm (AF line output / audio input) Jack 3.5 mm (REM / keypad) Jack 3.5 mm (external speaker) Jack 6.35 mm (key, front panel) Jack 6.35 mm (key, rear panel) Jack 6-pin (RTTY/Packet TNC) Jack 8-pin (microphone) Jack 8-pin (antenna tuner) Jack 15-pin (power amplifier) Jack 6-pin (antenna rotator) 10-pin miniDIN (u-Tune control) |
| Mechanical and environmental data |
| Operating temperature | |
|---|---|
| from -10°C to +50°C | |
| Dimensions | |
| 365 (W) x 115 (H) x 312 (D) mm | |
| Weight | |
| 10 kg |
- 1.8~54 MHz specified performance guaranteed, amateur bands only.
- 2.4 kHz bandwidth.
- 6.0 KHz bandwidth.
- 15 KHz bandwidth.
- 14 MHz, BW of 500 Hz, roofing filter 600 Hz.
- FTDX3000 optional filter XF-127CN.
- For Alaska emergency communications.
Updated | Complete | UK - NORTHERN IRELAND
378 pages | 300+ Airports and Airfields
Voice com. | ACC | FIC | VOLMET | ACARS | VDL | ILS | VOR | DME
Phenomenal multi-signal characteristics that were demonstrated in the FT-DX5000. Using the two signal dynamic range measuring method with 10 kHz signal separation, the FT-DX3000 performance is 108.5 dB, IP3 +37 dBm. (Test settings: CW 500 Hz bandwidth, Roofing Filter: 600 Hz and IPO is ON). With frequency separation of only 2 kHz between the desired signal and an interfering signal, the dynamic range measures 106 dB and IP3 +33 dBm. (Test settings: CW 500 Hz bandwidth, Roofing Filter: 600 Hz and IPO is ON).
Yaesu FT-DX3000 dynamic range and IP3 performance
The 3-step IPO settings permit the most appropriate gain for best signal reception. The IPO (Intercept Point Optimization) is selected by a control switch located on the front panel. The IPO selection determines the gain of the RF amplifier. The gain setting is very effective in optimizing the receiver performance, depending on the antenna and the communication propagation conditions. The IPO, the ATT and one stage of the RF amplifier are used to optimize the signal levels that are sent to the mixer. This is especially important for HF low-band operation. The "AMP1" uses one RF amplifier stage, and maintains a better balance between the sensitivity and the receiver performance (the gain is around 10 dB). In addition, "AMP 2" uses two stages of the RF amplification and can obtain higher sensitivity (the gain is around 17 dB). This variety of selections provides superior receiver performance and the best possible communications with changing band conditions.
FT-DX3000D price
We have collected for your convenience the Yaesu FTDX3000 sale price (UK Pounds) and its trend over time. Useful to guarantee a cheaper purchase of this radio and to put it for sale in the second-hand market. Of course offers, accessories, warranty terms and conditions can lead to different figures.
 Price |
 Date |
 Condition |
| GBP 1399.95 | 2021-jul | Brand-new |
FT-DX3000D review
Your opinion on merits, defects, experiences, with this radio set is welcome. Write your review, after a technical evaluation by our staff if found suitable will be published on this page. We thank you for your precious contribution.
Grundig, the flagship receiver
FM, LW, MW, 1.6-30 MHz
HF/50/70 MHz, 102dB IMDR, 100 Watt
All the frequencies, all the Countries
Copyright. All rights reserved.
 | This site agree to login-free initiative |