Triple-conversion HF desktop receiver. Analogical configuration, frequency range 0.03-60 MHz MHz all-mode. With Sync-AM and pass-band tuning (PBT). Ideated in Japan, year of introduction 1999.
Reference market : amateur-radio
IC-R75 specifications
General |
Frequency coverage [1] | |
---|---|
0.0300 ~ 60.0000 MHz | |
Mode | |
CW / RTTY / LSB / USB / AM / AM-S / FM | |
Tuning step | |
1 / 10 Hz
1 MHz |
Receiver |
Sensitivity | |
---|---|
SSB / CW | 2.0 uV (0.1~1.8 MHz, 10dB S/N)
0.16 uV (1.8~30 MHz, 10dB S/N) 0.13 uV (50~54 MHz, 10dB S/N) |
RTTY | 2.0 uV (0.1~1.8 MHz, 10dB S/N)
0.16 uV (1.8~30 MHz, 10dB S/N) 0.13 uV (50~54 MHz, 10dB S/N) |
AM / AM-S | 5.6 uV (0.1~1.8 MHz, 10dB S/N)
1.6 uV (1.8~30 MHz, 10dB S/N) 1.0 uV (50~54 MHz, 10dB S/N) |
FM | 0.22 uV (28~30 MHz, 12dB SINAD)
0.2 uV (50~54 MHz, 12dB SINAD) |
Selectivity | |
SSB / CW | > 2.1 KHz (-6dB)
< 4.0 KHz (-60dB) |
RTTY | > 2.1 KHz (-6dB)
< 4.0 KHz (-60dB) |
AM / AM-S | > 6.0 KHz (-6dB)
< 20 KHz (-50dB) |
FM | > 12 KHz (-6dB)
< 30 KHz (-40dB) |
IF filter ultimate attenuation [2] | |
80 dB | |
DR (Dynamic Range) [2] | |
95 dB (50 KHz spaced signals)
67 dB (5 KHz spaced signals) |
|
Blocking [2] | |
119 dB (100 KHz spaced signal) | |
Image rejection | |
119 dB (100 KHz spaced signal) | |
AGC (Automatic Gain Control) | |
Fast, slow, OFF | |
Frequency stability | |
± 7ppm max within 60' warm-up
± 1ppm/h max with temperature of 25°C ± 5ppm max with temperature from 0°C to +50°C |
|
IF (Intermediate Frequency) | |
1° | 69.0100 MHz (AM / AM-S)
69.0105 MHz (RTTY) 69.0106 MHz (CW) 69.0115 MHz (LSB / USB / FM) |
2° | 9.0100 MHz (AM / AM-S)
9.0105 MHz (RTTY) 9.0106 MHz (CW) 9.0115 MHz (LSB / USB / FM) |
3° | 450.0 KHz (AM / AM-S / FM)
455.0 KHz (LSB / USB) 455.9 KHz (CW) 456.0 KHz (RTTY) |
Features |
Memory | |
---|---|
99 regular memories
2 for scan limits |
|
Display | |
30-segments signal meter bar | |
Antenna | |
SO239 50Ω
Terminal jack 500Ω (0.03~1.8 MHz) |
|
Power supply | |
13.8 VDC external | |
Power consumption | |
1100 mA typ
900 mA squelch ON |
|
Audio power | |
2 W on 8Ω | |
Audio output | |
Jack 6.35 mm headphone
Jack 3.5 mm audio |
|
Connections | |
Jack 3.5 mm CI-V (PC) |
Mechanical and environmental data |
Operating temperature | |
---|---|
from 0°C to +50°C | |
Dimensions | |
241 (W) x 94 (H) x 229 (D) mm | |
Weight | |
3kg |
- 0.1~30 MHz and 50~54 MHz specifications guaranteed.
- This parameter, not in official data, was obtained with direct tests.
Updated | Complete | UK - NORTHERN IRELAND
378 pages | 300+ Airports and Airfields
Voice com. | ACC | FIC | VOLMET | ACARS | VDL | ILS | VOR | DME
The ICOM IC-R75 is a receiver with a peculiar history. With this model, the manufacturer has covered the gap left by the old R71, a valuable device in its period, due to the fact that the direct successor in time line, ie the R72, lacked functionality that became standard in other receivers. Although technologically outdated with regard to some circuit solutions, the IC-R75 is offered [2012, US market] in conjunction with the DSP module UT-106 dedicated to digital noise reduction (DNR). This module originally was an option.
The receiver has a limited number of commands on the front panel, so it is easy to operate, while integrating several functions. Among these the synchronous AM, the IF pass-band-tuning (PBT) with lower and upper cutoff frequencies independent adjustment, noise-blanker, automatic notch filter, DNR, AGC time constant selectable between two values or also off, continuous gain regulation in the IF stage, squelch, two RF preamplifiers, RF attenuator, internal clock and on / off timer. Tuning set by means of a rotary control, with direct input from the keypad, or even remote from a PC. The display is alphanumeric LCD, to facilitate the recognition of individual memory locations it is possible to associate a label up to 8 characters long, S-meter bar with good resolution to appreciate variations in the signal strength of 3dB up to S9. Standard search options: between band limits, within memories, on priority channel.
IC-R75 filters :
There are two positions for the installation of optional filters, one for the 2nd conversion IF and one for the 3rd conversion. Several the compatible models giving the user a considerable flexibility for the choice, the components are in the following table.
Filter FL-52A | |
---|---|
Mode | CW |
IF | 455 KHz |
Selectivity | 0.5 KHz (-6dB) 1.0 KHz (-60dB) |
Filter FL-53A | |
Mode | CW |
IF | 455 KHz |
Selectivity | 0.25 KHz (-6dB) 0.48 KHz (-60dB) |
Filter FL-96 | |
Mode | SSB |
IF | 455 KHz |
Selectivity | 2.8 KHz (-6dB) |
Filter FL-222 | |
Mode | SSB |
IF | 455 KHz |
Selectivity | 1.8 KHz (-6dB) 3.0 KHz (-60dB) |
Filter FL-257 | |
Mode | SSB |
IF | 455 KHz |
Selectivity | 3.3 KHz (-6dB) |
Filter FL-100 | |
Mode | CW |
IF | 9.0106 MHz |
Selectivity | 0.5 KHz (-6dB) 1.6 KHz (-60dB) |
Filter FL-101 | |
Mode | CW |
IF | 9.0106 MHz |
Selectivity | 0.25 KHz (-6dB) 0.8 KHz (-60dB) |
Filter FL-103 | |
Mode | SSB |
IF | 9.0115 MHz |
Selectivity | 2.8 KHz (-6dB) 5.0 KHz (-60dB) |
Filter FL-223 | |
Mode | SSB |
IF | 9.0115 MHz |
Selectivity | 1.9 KHz (-6dB) 3.6 KHz (-60dB) |
Filter FL-232 | |
Mode | CW / RTTY |
IF | 9.0106 MHz |
Selectivity | 0.35 KHz (-6dB) |
IC-R75 performance and practical notes :
In general terms the behavior in SSB and AM mode is adequate for the needs encountered in practical use, but not when extreme conditions exist. The dynamic-range on interfering signals placed at a great offset in frequency is in fact on good level, the contrary for few KHz separations where the effect of degradation becomes appreciable. This is due both to the excessive oscillator phase noise and to the mediocre ultimate attenuation guaranteed by the supplied IF quartz filters. The same filters, also having a bandwidth that satisfies most of the listening needs, are characterized by a mediocre form factor. This last point is perhaps the most critical element of the receiver. Directly a selectivity with insufficient slope in the response curve poses problems in handling amateur radio or utility traffic in crowded bands, indirectly this flaw is then emphasized with the use of the PBT that can not take full advantage of its potential. The possibility of installing one or two optional IF filters, with an optimal 6/60 dB ratio, significantly improves the performance. Some distributors to meet these requirements place on the market already receiver with an IF filter characterized by a better form factor. Pay attention to this aspect when evaluating a purchase. It should be noted that the receiver does not have a notch filter at the IF, the effective selectivity can not therefore be altered beyond the action of the pass-band tuning.
As with many other HF devices, the sensitivity is automatically reduced for frequencies below 1.8 MHz. Receiving test using the digital noise reduction function, obtained with the UT-106 module, has highlighted the usefulness of this processing without reaching high levels of sound improvement - this is probably due to a design not updated in the algorithms compared to the recent solutions.
IC-R75 price
We have collected for your convenience the ICOM IC-R75 sale price (UK Pounds) and its trend over time. Useful to guarantee a cheaper purchase of this radio and to put it for sale in the second-hand market. Of course offers, accessories, warranty terms and conditions can lead to different figures.
Price | Date | Condition |
GBP 262.00 (305EUR) |
2021-oct |
Second Hand The radio still looks very good and works flawlessly. Original power supply is included |
GBP 400.00 | 2018-oct |
Second Hand Good condition overall and perfect working, has the optional DSP UT-106 fitted. Also supplied a 13.8V / 5A high quality regulated power supply unit. Original box. This is completely stock and has not been hacked about with any modifications at all |
IC-R75 review
Sensitivity | |
Selectivity | |
Dynamic range | |
Spurious response | |
Audio | |
Signal functions | |
Control functions | |
User friendly | |
Stars: 1=insufficient | 2=just sufficient | 3=mediocre | 4=good | 5=excellent |
Rick | 29 may 2022 |
Bought one new on sale for $500.00 in 2010 still using it today, excellent sensitivity and SSB reception. Love the panel layout everything right where you need it can tune change modes / filters with one hand, and the keyboard entry is a must. They went all out on this radio to give you everything in a small compact setup. Have thought about selling it for the money but as of yet just not able to bring myself to give it up.
[End post]
Carlo | 24 march 2022 |
Excellent receiver, undoubtedly. For listening to utilities and HAM bands, it never bothered me. Purchased second hand, in excellent condition (like new and with original packaging). For my part, too, it will be very difficult to get it out of my shack.
[End post]
Angelo - IV3 | 23 may 2021 |
I have owned it since 2014 and its still as good as new even though I bought it second hand from a radio amateur who only used it for 2 months. I appreciate the IC-R75 and as long as it works I don't give it away despite having other receivers.
[End post]
Your opinion on merits, defects, experiences, with this radio set is welcome. Write your review, after a technical evaluation by our staff if found suitable will be published on this page. We thank you for your precious contribution.